PCB design

Carey Bunks over 5 years ago

Hi all,

I'm looking for some help with PCB design. Specifically, I'd like to collect data from a large number of MEMS microphones mounted on a single board. The mics are PDM devices that are clocked at about 3mHz, and then downsampled to 16 bit samples at 48kHz. At 3mHz, I'm concerned that the wires will act like antennas, and interfere with each other. Can anyone advise on best practice (or provide a reference)?

Cheers,

Carey

0 Nirav Chokshi over 5 years ago

Sorry to intervene but could this discussion not be done offline however interesting it may be!
Cancel
Vote Up 0 Vote Down

Cancel
0 Alex Barrett over 5 years ago

I agree, this isn't a place for technical discourse. My iet email is alex.barrett@ietvolunteer.org
Cancel
Vote Up 0 Vote Down

Cancel
0 Former Community Member over 4 years ago

Please also note. The mental processes for designing an Electronic circuit and that required for designing a PCB is completely different.
Cancel
Vote Up 0 Vote Down

Cancel
0 Alex Barrett over 4 years ago

As the Russians would say, “Da nyet”. They are different skills but I wouldn't want to lay out a circuit without some knowledge of the operation of that circuit.
Cancel
Vote Up 0 Vote Down

Cancel

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

PCB design

Join us to get the best from IET EngX.

Community Rules & Guidelines